After the fully automatic round wood push table saw is turned on, it must wait until the speed is normal before sawing. When sawing, the wood must not be shaken or lifted high or low, and the wood section must be delivered slowly and evenly. Saw material length should not be less than 100mm, near the end of the head, the application of push rod feed. Round wood multi-slice saw
1. It is mainly used for longitudinal sawing of small-diameter round wood. According to the pre-adjustment size, multiple pieces of board material can be sawn out at one time. It is widely used in the cutting process of small-diameter round wood sawing of Joinery boards and finger panels.
2. Compared with the high efficiency, high accuracy, simple and convenient operation of the strip saw, the technical requirements of the operator are not high, which makes up for the shortcomings of the low precision, low efficiency, and high technical requirements of the strip saw.
3. Saw blade cooling device, not easy to burn saw blade, extending the service life of saw blade.
4. Double row pointed tooth chain feed, simple and economical maintenance.
5. There is an active material separation guide device at the end of the feed, which is not easy to clip saw blades, which improves the smooth delivery of the feed.
6. The main axle box guide rail and feed guide rail use manual lubrication pump to supply oil, extending the service life of the guide rail
When the machine is in operation, the power supply should be shut down immediately when it is found to be abnormal. It should be reported to the workshop supervisor that non-professional maintenance personnel must not dismantle the machinery and equipment without authorization.
8, the machine must be dedicated, other personnel without the consent of the workshop supervisor, may not use without authorization.
It is strictly forbidden to wear gloves, slippers, and drunk operation machines.
10, the end of the operation, cut off the power, dust for the machine, clean up the residue, should be irregular refueling, maintenance
advantage
Automatic fixation of wood for pneumatic devices
After loading, the four pneumatic devices automatically press the plate, and the pressure is evenly cut and flattened. The labor intensity of this work is 0, and the occurrence of safety accidents is directly eliminated.
Second, the table automatically reciprocates
The counterboard reciprocates by the frequency conversion electrical device; The speed of uniform speed can be adjusted, and the plate is cut more neatly. There is no need to push and pull manually, greatly saving manpower to reduce the occurrence of safety accidents.
III. Automatic lifting of saw blades
The saw blade is automatically raised during work, and it is automatically lowered after completion. The saw saw does not sweep the edge, and the accuracy of saw cutting is higher, and safety accidents are also avoided.
Equipped with automatic feeding device(optional configuration)
After the plate is cut, the traction device automatically picks up the material. Reduce the use of labor and further reduce the occurrence of safety accidents.
